Under normal circumstances, the brake discs should be replaced every 60,000 to 80,000 kilometers. Brake discs are vulnerable parts in the car's braking system. As the mileage of the car increases, the...
Learn More >
Because of the large brittleness of single crystal diamond tool and the sharp edge, it is easy to collapse when impacted, so it should be used as far as possible under smooth and non-vibration working...
Learn More >
The manufacturing process of diamond tool is confidential at home and abroad, but the process is basically the same, one of the main processes is that the tool must go through crystal orientation befo...
Learn More >
The cutting gear is installed on the working structure of shearer and roadheader for cutting coal and rock directly. In the process of coal production, the consumption of a large number of picks not o...
Learn More >
In recent years, the producers and users of diamond products pay more and more attention to the thermal stability of the products. At present, the evaluation of the properties of diamond products is n...
Learn More >Linear velocity has the greatest influence on tool life. If the linear speed is higher than 20% of the specified linear speed of the sample, the tool life will be reduced by half. If increased to 50%,...
Learn More >
Tool life is the total cutting time of a new tool from the start of cutting until the tool is scrapped. In numerical control machining, tool life refers to the time that the tool tip cuts the workpiec...
Learn More >
Engine as a key part of the automobile, its cylinder block and cylinder head material is mostly aluminum alloy material, parts of the processing accuracy requirements are high, the traditional tool is...
Learn More >
